Page 1 of 1

F30-33-Watchdog, Parameter Memory/Write Error, Program Error

PostPosted: Thu May 24, 2012 11:42 pm
by HTP
Fault Codes F30-F33 - Watchdog, Parameter Memory, Parameter Memory Write Error, and Program Error

There was an error while programming the control and the memory is corrupt. The boiler control will not function in this state and the pump will be off. This error only occurs if a technician is programming the control and the programming function fails. The only way to recover from this error is to reprogram the control. If this error occurs at any time other than when a technician is servicing the boiler, the control has failed and must be replaced by a qualified technician.