F05 - Supply (outlet) temperature exceeds 230F

This forum contains videos for troubleshooting issues with the HTP ModCon line of boilers.

Moderator: Jason.Alpert

F05 - Supply (outlet) temperature exceeds 230F

Postby HTP » Thu May 24, 2012 11:27 pm

Fault Code F05 - Supply (outlet) temperature exceeds 230F

This display indicates that the supply temperature of the unit is excessive. If accompanied by the red FAULT light, this code indicates that the temperature on the supply sensor has exceeded 230F and a serious safety issue exists. The unit will not restart until the cause of excessive temperature is repaired by a technician and the RESET button is pushed on the display.
If the FAULT light is not illuminated and this message is displayed, then the supply temperature of the unit is at or above 210F. The message will clear automatically when the temperature drops below 194F. During the time that this message or lockout fault is displayed, the pump will be on.

User avatar
HTP
Site Admin
 
Posts: 186
Joined: Thu Dec 18, 2008 4:45 pm
Location: Massachusetts, USA

Return to Troubleshooting Videos

Who is online

Users browsing this forum: No registered users and 1 guest