F05 Fault Code: Supply Temperature High

This forum contains videos for troubleshooting issues with the HTP Mod Con VWH hot water supply boilers.

Moderator: Jason.Alpert

F05 Fault Code: Supply Temperature High

Postby HTP » Wed May 30, 2012 1:12 pm

This display indicates that the supply temperature of the boiler is excessive. If accompanied by the red FAULT light and LOCKOUT flashing on the display, this code indicates that the temperature on the sup-ply sensor has exceeded 230oF and a serious safety issue exists. The boiler will not restart until the cause of excessive temperature is repaired by a technician and the RESET button is pushed on the display. If the FAULT light is not illuminated and this message is displayed, then the supply temperature of the boiler is at or above 210oF. The message will clear automatically when the temperature drops below 194oF. During the time that this message or lockout fault is displayed, the pump will be on as indicated on the second line.

User avatar
HTP
Site Admin
 
Posts: 186
Joined: Thu Dec 18, 2008 4:45 pm
Location: Massachusetts, USA

Return to Troubleshooting Videos

Who is online

Users browsing this forum: No registered users and 1 guest

cron